Michael Bartlett
Contact
Professor
Department of Civil and Environmental Engineering
Spencer Engineering Building
Western University
mbartlet@uwo.ca
Publications 2011 - 2016
CHAPTERS IN BOOKS AND SYMPOSIA
- Bartlett, F.M. (2015). Chapter 6 - Deflections. Concrete Design Handbook, Cement Association of Canada, Ottawa, 37 pp.
- Bartlett, F.M. (2013). Chapter 5 - Loads, Load Combinations and Strength Reduction Factors of Code Requirements for Evaluation, Repair and Rehabilitation of Concrete Buildings (ACI 562-13) and Commentary. In Manual of Concrete Practice, American Concrete Institute, Farmington Hills, Michigan, 3 pp.
- Bartlett, F.M. (2011). Annex B: Reliability Assessment Methods, in CSA SP 408 Guidelines for the Development of Limit States Design Standards. Canadian Standards Association, Toronto, pp 22-26.
PEER-REVIEWED JOURNAL PAPERS
- Orta, L. and Bartlett, F.M. (2015). Reliability analysis of concrete deck overlays. Structural Safety, 56:30-38.
- Orta, L. and Bartlett F.M. (2014). Stresses due to restrained shrinkage in concrete deck overlays. ACI Materials Journal, 111(6):701-710.
- Orta L. and Bartlett F.M. (2014). Free shrinkage strain in concrete overlays. ACI Materials Journal, 111(3):263-272.
- Scott, T. and Bartlett F.M. (2013). Concrete girders with exposed flexural reinforcement. Structural Engineering International, 23(4):427-435.
- Liu, S., Bartlett, F.M. and Zhou, W. (2013). Alternative load paths in steel through-truss bridges: a case study. ASCE Journal of Bridge Engineering, 18(9):920-928.
- Bakht, B., King, J.P.C. and Bartlett, F.M. (2013). Wind-induced response and loads for the Confederation Bridge. Part I: on-site monitoring data, Wind and Structures, 16(4):373-391.
- Bakht, B., King, J.P.C. and Bartlett, F.M. (2013). Wind-induced response and loads for the Confederation Bridge. Part II: derivation of wind loads. Wind and Structures, 16(4):393-409.
- Orta, L. and Bartlett, F.M. (2012). Restrained concrete shrinkage in composite trusses. Canadian Journal of Civil Engineering, 39(7):779-788.
- Bakht, B., King, J.P.C. and Bartlett, F.M. (2012). Discussion of Operational Requirements for Long-span Bridges under Strong Wind Events. Journal of Bridge Engineering, 17(1):182-183.
- Bartlett, F.M. and Lawler, J.S. (2011). Strength compliance evaluation with more than three core specimens. ACI Concrete International, 33(12):46-49.
- Sezen, H., Hookham, C., Elwood, K., Bartlett, F.M. and Moore, M. (2011). Core testing requirements for seismic evaluation of existing reinforced concrete structures. Concrete International, 33(11):43-48.
PAPERS IN REFEREED CONFERENCE PROCEEDINGS
- Mancuso, C. and Bartlett, F.M. (2014). Built-up wrought-iron compression member with missing stitch rivets. Electronic Proceedings, 37th International Association for Bridge and Structural Engineering Symposium, Madrid, 10 pp.
- Macdonald, A.J., Bartlett, F.M., Tanovic, R. and Wright, R.G. (2014). Probabilistic quantification of military vehicle loadings". CD-ROM Proceedings of the 9th International Conference on Short and Medium Span Bridges, Calgary, 11 pp.
- Westerink, H.M. and Bartlett, F.M. (2014). Accuracy of CHBDC Simplified Methods of Analysis. CD-ROM Proceedings of the 9th International Conference on Short and Medium Span Bridges, Calgary, 10 pp.
- Herrell, M. and Bartlett, F.M. (2014). Prefabricated built-up hybrid steel compression members. CD-ROM Proceedings, Canadian Society for Civil Engineering 4th International Structures Specialty Conference, Halifax, 10 pp.
- Scott, T. and Bartlett, F.M. (2013). Partially-repaired reinforced concrete beams with exposed reinforcement. Electronic Proceedings, International Association for Bridge and Structural Engineering “Assessment, Upgrading and Refurbishment of Infrastructure” Conference, Rotterdam, 10 pp.
- Bartlett, F.M. and Johnston, G. (2012). Restrained shrinkage in concrete flexural elements. Electronic Proceedings, 3rd International Canadian Society for Civil Engineering (CSCE) Structural Specialty Conference, Edmonton, Paper STR-1137, 10 pp.
- Scott, T. and Bartlett, F.M. (2012). Partially repaired reinforced concrete beams with exposed flexural reinforcement”. Electronic Proceedings, 3rd International CSCE Structural Specialty Conference, Edmonton, Paper STR-1033, 10 pp.
- Grenier, D. and Bartlett, F.M. (2012). Load-slip response of gypsum-board-to-stud fastener connections in shear. Electronic Proceedings, 3rd International CSCE Structural Specialty Conference, Edmonton, Paper STR-1236, 10 pp.
- Banson, A. and Bartlett, F.M. (2012). Influence of the modular ratio on the bond stress distribution along a reinforcing bar. Electronic Proceedings, 3rd International CSCE Structural Specialty Conference, Edmonton, Paper STR-1028, 10 pp.
- Bartlett, F.M. (2012). Using historical cylinder strength data for structural evaluation. Proceedings, Andrew Scanlon Symposium, American Concrete Institute Special Publication, 11 pp.
Articles in Other Journals and CONFERENCE PROCEEDINGS
- McNeil, Z.T. and Bartlett, F.M. (2013). Effective length of cable-stayed bridge decks. CD-ROM Proceedings, 3rd CSCE Specialty Conference on Material Engineering and Applied Mechanics, Montreal, 10 pp.
- Krisciunas, A. and Bartlett, F.M. (2011). Local buckling in corroded steel bridge compression members. CD-ROM Proceedings, 39th Annual General Conference of the CSCE, Ottawa, 10 pp.
- Liu, S., Bartlett, F.M. and Zhou, W. (2011). Load paths in single load path through truss bridges – a case study”. CD-ROM Proceedings, 39th Annual General Conference of the CSCE, Ottawa, 10 pp.
- Grenier, D. and Bartlett, F.M. (2011). Contribution of drywall sheathing to stiffness and capacity of axially loaded sheathed stud walls. CD-ROM Proceedings, 39th Annual General Conference of the CSCE, Ottawa, 10 pp.
- Blaylock, J. and Bartlett, F.M. (2011). Niche areas for mid-rise light-frame wood-concrete hybrid construction. CD-ROM Proceedings, 39th Annual General Conference of the CSCE, Ottawa, 10 pp.
ABSTRACTS AND PROFESSIONAL PRESENTATIONS
- Bartlett, F.M. (2013). Canadian Journal of Civil Engineering: A Snapshot. Breakfast address, Canadian Society for Civil Engineering Annual Conference, Montreal.
- Bartlett, F.M. (2012). Reflections: Breaking in an Iron Ring. Western Society of Civil Engineering Annual Banquet.
- Bartlett, F.M. (2012). Structural Engineering a Century Ago: A Tale of Two Bridges. Canadian Society for Civil Engineering/Canadian Geotechnical Society London and District Section, and Robert and Joyce Jones Civil Engineering Forum, Queen's University, Kingston (2011).
- Bartlett, F.M. (2011). 2011Snapshot of the Canadian Journal of Civil Engineering. Canadian Society for Civil Engineering Annual Workshop, Niagara-on-the-Lake.
- Bartlett, F.M. (2011). A Snapshot of Current Development of CSA Standard A23.3-14. Structural Engineering Seminar Series, University of Waterloo.
- Bartlett, F.M. (2011). Mechanics of Highway Bridge Rehabilitation”. Canadian Society for Civil Engineering London & District Section Meeting, and Graduate Research Forum, McMaster University.
- Bartlett, F.M. (2011). New Provisions in Clause 14 of the 2010 Canadian Highway Bridge Design Code. Canadian Society for Civil Engineering in Winnipeg, Toronto and Ottawa.
- Bartlett, F.M. (2011). Structural Engineering a Century Ago: A tale of two bridges. Robert and Joyce Jones Civil Engineering Forum, Queen’s University at Kingston.
TECHNICAL WRITINGS
- Bartlett, F.M. (2014). PEO Complaint re: Application of Canadian Highway Bridge Design Code. Produced for the Legal Services Branch, Ontario Ministry of Transportation, 2 pp.
- Morrison Hershfield Limited, Bartlett, F.M. & El Damatty A. (2012). Bridge Design Training -- Design Examples. Produced for the Provincial Highways Management Division of the Ontario Ministry of Transportation, 281 pp.
- Bartlett, F.M. (2012). Structural Testing of Cold-formed Steel Connections for a Photo-voltaic Cell Racking System. Technical Report for Presstran Industries, 59 pp.
- Bartlett, F.M. (2012). Structural Testing of Cold-formed Steel Connection 2 for a Photo-voltaic Cell Racking System. Technical Report for Presstran Industries, 16 pp.
- Bartlett, F.M. (2011). 1870s Structural Engineering in Blackfriars Bridge. Technical Report for Archaeological Services Inc./Dillon Consulting Ltd./City of London, 16 pp.
- Bartlett, F.M. (2011). U.S. Patents of the Wrought Iron Bridge Company. Technical Report for Archaeological Services Inc./Dillon Consulting Ltd./City of London, 13 pp.
- Bartlett, F. M. & Scott, T. (2011). Accuracy of 1910-era Structural Analysis of Meadowlily Bridge. Technical Report for Golder Associates/AECOM/City of London, 7 pp.